Basics Of Placing Carpet On Stairs

Image result for carpet for stairs

There are basically 2 techniques of installing carpet on stairs. One is the waterfall technique where one piece of carpet covers each riser and tread. The other is the cap and band installation. In this case the cap is a piece of carpet installed over the treads and the band is the piece that will cover the risers best carpet for stairs. In this article I will show you ways to set up carpet utilizing the waterfall technique. These guidelines are for basic stairs and not for spiral stairs which would require extra treatments.

Tools Needed:

Tack strips

Staples or upholstery nails

Determining Tape

Knee Pads

Knee kicker (check your rental shop).

Stair Tool (examine your rental shop).

Energy knife.

Hammer.

Shatterproof glass.

Obviously you’ll need to remove all the old carpet. Get rid of the tack strips and do not try to utilize the old padding. Ensure any nails and staples are eliminated and sweep down the area to be carpeted.

Before you start you’re going to need to figure out how much carpet you’ll require. To compute the width merely determine across the tread. If your stairs are open on one or both ends ensure to measure under the nosing to where it meets the riser and add it to the total width. Figure the overall length of your flight of stairs by measuring the tread and riser. Assuming your going to utilize rug make sure to include at least 3 inches per stair. If your steps have nosing include one foot to the total flight measurement.

Okay, let’s start. Apply the tack strip to the stair crotch place. Next you’ll have to tighten the carpet by tucking in the crotch. You can do this by using a knee kicker. It is a tool utilized to install carpet in small areas and stairs. It includes a piece of metal tubing with a pin plate attached to it. On the other end it has a cushioned cushion where you can position your knee to use pressure to the carpet. You need to be able to find one at your local rental store. Simply put the cushioned end several inches above your knee and include pressure.

This is where you will utilize the knee kicker:.

To attach to the tack strip you need to use the knee kicker to extend the carpet directly from the center of the tread and hook it to the tack strip located at the crotch. Once the carpet has been hooked to the tack strip you have to securely connect it by moving your carpet tool backward and forward to compress the pins. Utilizing your energy knife or carpet knife trim as required. A carpet knife is better as it has 2 sides and is sharper than an energy knife. Repeat this process on each side of the tread. Prior to going to the next tread make sure the carpet is smoothed out on the riser and after that staple to the stair lip. I would recommend you staple about every 2 inches. Do not forget to likewise essential along the edge of the riser.

Make sure to step back and take a look at your work before going on to the next tread. Is the carpet smooth? Did you kick it in uniformly? It is likewise a good time to offer your knees and back a rest. If whatever looks great the continue onto the next tread. If not you’ll have to pull the carpet off and install it once again. Repeat this procedure till you are finished.

 

Ashu Rawat

Related posts